Talk:Structural shape rolling

is there any difference between roll forming and shape rolling? yes , in shape forming our aim is not to change in cross section of input, but only change the shape to get desired shape of product. — Preceding unsigned comment added by 115.245.200.64 (talk) 14:34, 24 June 2016 (UTC)Reply

There are a lot of different terms and meanings which this article does not tease out. The article rolling (metalworking) does a much better job of distinguishing, explaining, and illustrating them. I propose that this entire article be replaced by a redirect to that article.Jefflayman (talk) 20:05, 11 January 2019 (UTC)Reply

Content Disclaimer

Informasi ini disarikan dari Wikipedia dan disajikan kembali untuk tujuan edukasi. Konten tersedia di bawah lisensi CC BY-SA 3.0. Kami tidak bertanggung jawab atas ketidakakuratan data yang bersumber dari kontribusi publik tersebut.

  1. The information displayed on this website is sourced in part or in whole from Wikipedia and has been adapted for the purpose of restating it. We strive to provide accurate and relevant information, however:
  2. There is no guarantee of absolute accuracy. Wikipedia is an open, collaborative project that can be edited by anyone, so information is subject to change.
  3. It is not intended to constitute professional advice. The content displayed is for informational and educational purposes only. For important decisions (e.g., medical, legal, or financial), please consult a professional.
  4. Content copyright. Wikipedia is licensed under the Creative Commons Attribution-ShareAlike License (CC BY-SA). This means that content may be reused with appropriate attribution and shared under a similar license.
  5. Responsible use. Any risk arising from the use of information from this website is entirely the responsibility of the user.